3d Printer Optimal Ender 3      Legal:Links on this site may pay us a commission at no extra cost to yourself. Member Amazon affililate program.


ABS Flash Forge





Amazon
Ebay Refurb
Banggood
Aliexpress
Cafago
DHgate
Ender3 V3



Support Via Community

More Info here...



Z-axis Dual

Closed loop Stepper Motors

Filament Dryer


Direct Drive Extruder


Easy install. I like that this is a complete unit; direct swap for existing hot end and drive unit. Instructions could be better. All that came with the kit was a color photo showing connections to older style 12v motherboard. I installed mine on a Creality Ender 3 v2 which has the 24v motherboard. I suggest taking a picture of your existing connections prior to disassembly as the connections are direct swap. Also reduce your retraction settings and speed. Keeping your original settings could cause a clog in the hot end based on research I did online. I changed my settings from 5 to 1 mm on the retraction  Filament Fusing
TypeII
Type III
Video
Video II using Teflon
Y  Drag Chain
Thingiverse or ...

Ebay
Amazon

                            
Laser Upgrade
Video
Software

Lightburn
Set to Marlin
Change the baud rate in settings to lowest, closed program then reopened the program and it connected! So far all I have tried is homing from laser control and it works.



I managed to fix the issue by reducing the port speed to 115200
Now, the console receives info from the printer, and responds with OK,

Workflow CR10
Update firmware
TH3Dstudio.com website
Mac Driver
Teaching Tech Video for ender 3 needs driver board for 24v

Laser Kit with Instructions for Ender 3
This one seems to be complete with driver specific to ender 3 off of fan. One might wish to see if light burn can control ender 3 off of bltoouch output.

Laser kit with buck module 4 watt

48 watt with pwm 3.3v 0-5v


40watt unit that connects directly to ender

Conclusion: The 24 volts needs to be tailored to send  to give a ttl signal of around 3.3 volts for the 48 watt laser.  Use an opto isolator as below.


 PMW0-3.3V or 0-5V control signal can meet the control of the laser head.
Tent Flameproof


24" Depth Version

Cable Extension Kits
Liquid Cooling Kit
Metal Server Case 12u
  • Dimensions:
  • 24.42" H
  • 21.65" W 
  • 17.72" D
  • 110 pound weight capacity
  • Sturdy welded frame structure
  • Rails with cage nut style bolting
  • Total Usable Space of 13.75" front to back.
Metal Server Case 15u Unit
Dimensions
Item Height29.6"
Item Width21.6"


Atomstack Diode Lasers









\
This is for controlling a 12v input laser with no TTL or PWM input.


Laser with TTL PWM input.
40watt with controller for ender 3 direct

Interface for head without conversion of 24 control.
   
Article for below
This from the printer Out of a Merlin board with 24 volts.

Opto isolator

Conclusion: The 24 volts needs to be tailored to send  to give a ttl signal of around 3.3 volts for the 48 watt laser. The 5 volts can come from an usb voltage source or voltage divider.
Ebay Piece
Can not be used to drive directly as that the caps create hysteresis.

Possible  solution for laser without 24 volt conversion...









Rail Kit
Drawer for Electronics

Drag Chain
Ender 3
Direct Extruder Kit
Enclosure Tent Flame Proof
Enclosure Metal Server Case
Cooling System for high Heat