| Good Settings Laser Master 1 |
This setup did not work |
Myers work through |
| $$ $0=20 (Step pulse time, microseconds) $1=50 (Step idle delay, milliseconds) $2=0 (Step pulse invert, mask) $3=1 (Step direction invert, mask) $4=0 (Invert step enable pin, boolean) $5=0 (Invert limit pins, boolean) $6=0 (Invert probe pin, boolean) $10=1 (Status report options, mask) $11=0.050 (Junction deviation, millimeters) $12=0.002 (Arc tolerance, millimeters) $13=0 (Report in inches, boolean) $20=1 (Soft limits enable, boolean) $21=1 (Hard limits enable, boolean) $22=1 (Homing cycle enable, boolean) $23=7 (Homing direction invert, mask) $24=600.000 (Homing locate feed rate, mm/min) $25=3000.000 (Homing search seek rate, mm/min) $26=100 (Homing switch debounce delay, milliseconds) $27=2.000 (Homing switch pull-off distance, millimeters) $30=1000 (Maximum spindle speed, RPM) $31=0 (Minimum spindle speed, RPM) $32=1 (Laser-mode enable, boolean) $33=250.000 $100=80.000 (X-axis travel resolution, step/mm) $101=80.000 (Y-axis travel resolution, step/mm) $102=80.000 (Z-axis travel resolution, step/mm) $110=9000.000 (X-axis maximum rate, mm/min) $111=9000.000 (Y-axis maximum rate, mm/min) $112=9000.000 (Z-axis maximum rate, mm/min) $120=2200.000 (X-axis acceleration, mm/sec^2) $121=1800.000 (Y-axis acceleration, mm/sec^2) $122=2500.000 (Z-axis acceleration, mm/sec^2) $130=160.000 (X-axis maximum travel, millimeters) $131=150.000 (Y-axis maximum travel, millimeters) $132=1.000 (Z-axis maximum travel, millimeters) |
$$ $0=20 $1=50 $2=0 $3=1 $4=0 $5=0 $6=0 $10=1 $11=0.050 $12=0.002 $13=0 $20=1 $21=1 $22=1 $23=7 $24=600.000 $25=3000.000 $26=100 $27=2.000 $30=1000 $31=0 $32=1 $33=250.000 $100=80.000 $101=80.000 $102=80.000 $110=18000.000 $111=18000.000 $112=18000.000 $120=2200.000 $121=1800.000 $122=2500.000 $130=160.000 $131=150.000 $132=1.000 |